Grandstream Networks Grandstream BudgeTone 200 User Manual download pdf (Page 33)

Admin

Password

Administrator password. Only administrator can configure the “Advanced

Settings” page. Password field is purposely left blank for security reason

after clicking update and saved. The maximum password length is 25

characters.

Silence

Suppression

This controls the silence suppression/VAD feature of G723 and G729. If set

to “Yes”, when a silence is detected, small quantity of VAD packets (instead

of audio packets) will be sent during the period of no talking. If set to “No”,

this feature is disabled.

Voice Frames

per TX

This field contains the number of voice frames to be transmitted in a single

packet. When setting this value, the user should be aware of the requested

packet time (used in SDP message) as a result of configuring this parameter.

This parameter is associated with the first vocoder in the above vocoder

Preference List or the actual used payload type negotiated between the 2

conversation parties at run time.

e.g., if the first vocoder is configured as G723 and the “Voice Frames per

TX” is set to be 2, then the “ptime” value in the SDP message of an INVITE

request will be 60ms because each G723 voice frame contains 30ms of

audio. Similarly, if this field is set to be 2 and if the first vocoder chosen is

G729 or G711 or G726, then the “ptime” value in the SDP message of an

INVITE request will be 20ms.

If the configured voice frames per TX exceeds the maximum allowed value,

the BudgeTone 200 will use and save the maximum allowed value for the

corresponding first vocoder choice. The maximum value for PCM is

10(x10ms) frames; for G726, it is 20 (x10ms) frames; for G723, it is 32

(x30ms) frames; for G729/G728, 64 (x10ms) and 64 (x2.5ms) frames

respectively.

Layer 3 QoS

This field defines the layer 3 QoS parameter which can be the value used for

IP Precedence or Diff-Serv or MPLS. Default value is 48.

Layer 2 QoS

This contains the value used for layer 2 VLAN tag. Default setting is

blank.

No Key Entry

Timeout

Default is 4 seconds.

Use # as

Send Key

This parameter allows users to configure the “#” key to be used as the

“Send” (or “Dial”) key. If set to “Yes”, pressing this key will immediately

trigger the sending of dialed string collected so far. In this case, this key is

essentially equivalent to the “(Re)Dial” key. If set to “No”, this “#” key will

then be included as part of the dial string to be sent out.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 53 54

Comments to this Manuals

No comments

Grandstream Networks Grandstream BudgeTone 200 User Manual Page 33

Comments to this Manuals

Related products and manuals for IP phones Grandstream Networks Grandstream BudgeTone 200