Grandstream Networks GXW410X User Manual download pdf (Page 24)

Apply test results

automatically

Default is No. If selected on Yes, then all the results from the test will be applied

automatically. If you select No you will have to monitor the Syslog output. This is only

reserved for very advanced users.

Apply test results to all

ports

Default is No. If selected on Yes, then all the test results will be applied to all ports on

the gateway. If all the lines belong to the same service provider or PBX it will make

sense to apply the results to all ports.

Error Timeout

This is the time the gateway will wait to exit the test mode, when something

unexpected or an error has occurred.

TABLE 11: CHANNELS PAGE DEFINITIONS

Note – The channels here are basically SIP endpoints that will act as clients

registering to the SIP Server configured under the appropriate Profile page.

Channels

It should be set same as the channel number (i.e 1, 2..4 or 8 depending on number of

FXO ports). It is NOT the same as SIP Account ID.

SIP User ID

This is the SIP account information. Enter the SIP User ID part of the account.

Authentication ID

SIP service subscriber’s Authenticate ID used for authentication. It can be identical

to, or different from SIP User ID.

Authentication Password

SIP account password needs to be entered here.

Note: After entering the password, it will show up as blank but the password still

remains active.

Profile ID

Select the corresponding Profile ID (1/2/3). Profiles are SIP Server configurations.

Call Progress Tones

Using these settings, user can configure tone frequencies according to user

preference. By default, the tones are set to North American frequencies.

Frequencies should be configured with known values to avoid uncomfortable high

pitch sounds. ON is the period of ringing (ON time in ms) while OFF is the period of

silence. In order to set a continuous ring, OFF should be zero. Otherwise it will ring

ON ms and a pause of OFF ms and then repeat the pattern.

• “Dial tone”

• “Ringback tone”

• “Busy/Re-order tone”

• “Confirmation tone”

Please refer the document below to determine your local call progress tones

(http://www.itu.int/ITU-T/inr/forms/files/tones-0203.pdf) or run the FXO Line Test

(Table 10).

Channel Voice Settings

Channel voice settings mentioned below.

Tx to PSTN Audio Gain (dB)

Allows user to set a value in dB for transmission to PSTN Audio Gain. Default is 1.

Range is from -12 to 12dB.

Rx from PSTN Audio Gain

(dB)

Allows user to set a value in dB for receive from PSTN Audio Gain. Default is 0.

Range is from -12 to 12dB.

Silence Suppression

This controls the silence suppression/VAD feature of G723 and G729. If set to “Yes”,

when a silence is detected, small quantity of VAD packets (instead of audio packets)

will be sent during the period of no talking. If set to “No”, this feature is disabled.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 35 36

Comments to this Manuals

No comments

Grandstream Networks GXW410X User Manual Page 24

Comments to this Manuals

Related products and manuals for Gateways/controllers Grandstream Networks GXW410X