Grandstream Networks, Inc. GXW40XX User Manual Page 28 of 38
Firmware 1.0.4.2 Last Updated: 06/2011
This feature enables the gateway to register all existing FXS
phone number. Each incoming call will be routed to first available port in round robin
mode. User may configure all ports as members of the same Hunting
configure different port combinations for more than one Hunting Group.
For example: Ports 1, 3 and 5 are members of the same Hunting G
the ports may have separate numbers and may be reached independently.
Any port, member of a Hunting Group that is not registered with a SIP account, will be
able to place outbound calls using the SIP credentials of the primary Hunting Group
port.
For example: Port 1, 3 and 5 are members
of the same Hunting Group. Port 1 is
registered with a SIP account. Ports 3 and 5 are not registered.
able to place outbound calls using the SIP account of port 1.
Select appropriate value for Hunting Group feature. The original SI
P account should
be set to Active while the group members should be set to the port number of the
Active Port.
Example configuration of a multiple Hunting group:
FXS Port #1: SIP UserID and Authenticate ID entered, Hunting group set to "Active"
FXS Port #2: SIP UserID and Authenticate ID left blank, Hunting Group set to "1"
FXS Port #3: SIP UserID and Authenticate ID left blank, Hunting Group set to "1"
FXS Port #4: SIP UserID and Authenticate ID entered, Hunting group set to "Active"
FXS Port #5: SIP UserID and Authenticate ID left blank, Hunting Group set to "4"
FXS Port #6: SIP UserID and Authenticate ID left blank, Hunting Group set to "4"
FXS Port #7: SIP UserID and Authenticate ID entered, Hunting group set to "Active"
FXS Port #8: SIP UserID and Authenticate ID left blank, Hunting Group set to "7"
Hunting Group 1 contains ports 1, 2, 3. Hunting Group
4 contains ports 4, 5, 6.
Hunting Group 7 contains ports 7, 8.
This feature allows you
to automatically dial the number specified in this field as soon
as the port is offhooked, i.e. when the receiver on the phone connected to Port# is
This is used only when peering with a Grandstream GXW410x. Default is 1,
Supported values are 1-8, meaning line 1 to line 8 of the GXW410x device
where the
port will be mapped to.
This is used when peering with an FXO gateway of any brand. You have to
specifically mention the IP and sip port where the call will be sent to.
Sip port that will be annexed to the IP address above.
Comments to this Manuals