Grandstream Networks BudgeTone-200 User Manual download pdf (Page 15)

Grandstream Networks, Inc. BT200 User Manual Page 15 of 33

Firmware 1.1.5.15 Last Updated: 01/2008

#XX or #X are also valid so leading 0 is not required (but OK).

eg.

192.168.0.2 calling 192.168.0.3 just dial #3 follow by SEND or #

192.168.0.2 calling 192.168.0.23 just dial #23 follow by SEND or #

192.168.0.2 calling 192.168.0.123 just dial #123 follow by SEND or #

192.168.0.2 dial #3 and #03 and #003 has same effect --> call 192.168.0.3

Note:- If you have a SIP Server configured, Direct IP-IP call will still work. However, if you are using

STUN, Direct IP-IP call will also use STUN.

To make a direct IP to IP call, first off hook, then press “MENU” key, then enter a 12-digit target IP

address to make the call. If port is not default 5060, destination ports can be specified by using “*4”

(encoding for “:”) followed by the port number.

Examples:

• If the target IP address is 192.168.0.10, the dialing convention is

MENU_key 192 168 000 010

followed by pressing the “SEND” key or wait for seconds in the No Key Entry Timeout.

• If the target IP address/port is 192.168.1.20:5062, then the dialing convention would be:

MENU_key 192168001020*45062

followed by pressing the “SEND” key wait for seconds in the No Key Entry Timeout.

Quick IP Call Mode

The BT200 also supports Quick IP call mode. This enables the phone to make direct IP-calls, using only

the last few digits (last octet) of the target phone’s IP-number.

This is possible only if both phones are in under the same LAN/VPN. This simulates a PBX function using

the CMSA/CD without a SIP server. Controlled static IP usage is recommended.

Setting up the phone to make Quick IP calls

To enable Quick IP calls, the phone has to be setup first. This is done through the web-setup function. In

the “Advanced Settings” page, set the "Use Quick IP-call mode to YES. When #xxx is dialed, where x is

0-9 and xxx <=255, a direct IP call to aaa.bbb.ccc.XXX is completed. “aaa.bbb.ccc” is from the local IP

address regardless of subnet mask. The numbers #xx or #x are also valid. The leading 0 is not required

(but OK).

For example:

192.168.0.2 calling 192.168.0.3 -- dial #3 follow by SEND or #

192.168.0.2 calling 192.168.0.23 -- dial #23 follow by SEND or #

192.168.0.2 calling 192.168.0.123 -- dial #123 follow by SEND or #

192.168.0.2: dial #3 and #03 and #003 results in the same call -- call 192.168.0.3

NOTE: If you have a SIP Server configured, a Direct IP-IP still works. If you are using STUN, the Direct

IP-IP call will also use STUN. Configure the “Use Random Port” to “NO” when completing Direct IP calls.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 32 33

No comments

Grandstream Networks BudgeTone-200 User Manual Page 15