Grandstream Networks BudgeTone-200 User Manual download pdf (Page 27)

Grandstream Networks, Inc. BT200 User Manual Page 27 of 33

Firmware 1.1.5.15 Last Updated: 01/2008

Call Progress

Tones

Using these settings, users can configure ring or tone frequencies based on parameters

from local telecom. By default, they are set to North American standard.

Frequencies should be configured with known values to avoid uncomfortable high pitch

sounds.

Syntax: f1=val,f2=val[,c=on1/off1[-on2/off2[-on3/off3]]];

(Frequencies are in Hz and cadence on and off are in 10ms)

ON is the period of ringing (“On time” in ‘ms’) while OFF is the period of silence. In order

to set a continuous ring, OFF should be zero. Otherwise it will ring ON ms and a pause

of OFF ms and then repeat the pattern. Up to three cadences are supported.

Disable Call

Waiting

Default is No. If set to Yes, the call waiting will be disabled.

Use Quick IP

Call Mode

Dial an IP address under the same LAN/VPN segment by entering the last octet in the IP

address.

In the Advanced Settings page there is an option "Use Quick IP-call mode". Default

setting is No. When set to YES, and #XXX is dialed, where X is 0-9 and XXX <=255,

phone will make direct IP call to aaa.bbb.ccc.XXX where aaa.bbb.ccc comes from the

local IP address REGARDLESS of subnet mask.

#XX or #X are also valid so leading 0 is not required (but OK). See Quick IP Call Mode

for details.

Lock keypad

update

If set to “Yes”, the configuration changes via keypad are disabled.

Table 12: SIP Account Settings

Account Name

The name associated with each account - displayed on LCD.

SIP Server

SIP Server’s IP address or Domain name provided by VoIP service provider.

Outbound Proxy

IP address or Domain name of Outbound Proxy, Media Gateway, or Session

Border Controller. Used for firewall or NAT penetration in different network

environment. If the system detects symmetric NAT, STUN will not work. ONLY

outbound proxy can provide solution for symmetric NAT.

SIP User ID

User account information provided by VoIP service provider (ITSP); either an

actual phone number or formatted like one.

Authenticate ID

SIP service subscriber’s Authenticate ID used for authentication. It can be

identical to or different from SIP User ID.

Authenticate Password

SIP service subscriber’s account password for BT200 to register to (SIP) servers

of ITSP.

Name

SIP service subscriber’s name that is used for Caller ID display.

Use DNS SRV

Default is No. If set to “Yes”, the client will use DNS SRV to look up server.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 33

Comments to this Manuals

No comments

Grandstream Networks BudgeTone-200 User Manual Page 27

Comments to this Manuals

Related products and manuals for IP phones Grandstream Networks BudgeTone-200